4. Specifications

4.1 Specification of Electrical Parameter

• Note ⑤: RG is the range value; ⑥: FS = voltage range value × current range value, when the phase angle is within 75°.

4.2 Specification of Magnetic Parameter

• Test conditions: (23 ± 5)℃, the specimen should be demagnetized before testing.

• Accuracy of measurement value: 1% to 2% deviation will occur depending on the way and position of loading the specimen in the measurement frame.

• Repeatability of measurement value: The same specimen is placed in the specified position and kept without moving, and measured repeatedly 10 times. Calculation method: Repeatability = (maximum value - minimum value) ÷ average value × 100%.

• Note ①: The table only gives reference test points. The Hm, Jm / Bm, Ps and other indicators that the sample can achieve during actual testing are related to the performance, quality, test frequency, test current, load voltage, etc. of the material.

• Note ②: J₁₀ refers to the magnetic polarization strength when the magnetic field H is 10 A/m, and so on. The brackets are typical test points for non-oriented steel.

• Note ③: P_0.1 refers to the total loss value when the magnetic flux B is 0.1 T. The maximum test point is the maximum test point marked at 0°.

• Note ④: K_J = J_δ / J_0°, the test specimen is a circular specimen.

• Note ⑤: K_Ps = Ps_δ / Ps_0°, the test specimen is a circular specimen.

4.3 TS2000-SST Full Angle Single Sheer Tester

4.4 Specimen

4.5 General Specification

• Power supply: AC (220 ± 22) V, (50 ± 2) Hz

• Working environment: 0 ℃ ~ 40 ℃, 20% ~ 85% R·H, no condensation

• Air supply requirements: Compressed air pressure not less than 0.6 MPa, air consumption not less than 100 L/min

• Air source can be purchased from an air compressor or installed at the site

5. Configuration List

• Note: The above is for reference only. The specific configuration list shall be subject to the technical agreement.